Yamaha LPX-500, Руководство пользователя

Страница: 28 / 80

Functions for Enhancing Projection
24
This adjusts the hues of light shades to the desired hues.
Three modes are available, for adjusting Color Temperature , flesh tones and each individual RGB color.
These adjustments are cumulative, so first carry out the basic "Color Temp." and "Flesh Tone" adjustments
while referring to the graph below, and then make fine adjustments using the "Color Balance" command.
Use the "Color Temp.", "Flesh Tone" and "Color Balance" commands in the "Image" menu to adjust.
(p.27, 29)
Color temperature and flesh tone adjustment modes
•••• The "Color Temp." setting allows lighter colors to be
adjusted so that they range from having a red tinge to
having a blue tinge. When the color temperature is
lower, the red content is greater and color tones appear
softer. When the color temperature is higher, the blue
content is greater and color tones appear fresher.
••••
The "Flesh Tone" setting adjusts the green component
of image signals. If adjusted to the - side, the green
component is reduced and colors appear purplish. If
adjusted to the + side, the green component is increased.
Adjust until the desired flesh tones are obtained.
Up to a maximum of six adjustment values in the "Image" and "Signal" menus can be memorize per input
source, and settings for six different sources can be recorded, for a total of 36 possible settings. You can save
the adjustment values for particular video scenes, and then use the memory button on the remote control to
retrieve these settings at a single touch. (p.27, 29)
The following adjustment values can be stored in memory.
•••• Image menu:
Black Level, White Level, Saturation, Hue, Picture Mode, Color Temp., Flesh Tone, Color Balance, Sharpness
•••• Signal menu:
Progressive, Noise Reduction, Setup Level
•••• Aspect ratio setting
This is the aspect ratio that is selected using the [ASPECT] button on the projector's control panel or the remote
control.
Procedure
1
Press the [MENU] button on either the
projector's control panel or the remote
control.
The menu will be displayed, with the adjustment
values appearing as are currently set.
Color temperature, flesh tone and color balance adjustment
Saving and Retrieving Image Quality Settings (Memory Save)
Saving Settings
Change in colour
temperature
+ flesh tone correction
Dark object locus
- flesh tone correction
Projector
Remote control