Yamaha FZ-09 2013, Руководство пользователя

Страница: 30 / 116

INSTRUMENT AND CONTROL FUNCTIONS
4-12
4
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “ ”
Press this switch to sound the horn.
EAU54211
Start/En g ine stop switch “ / / ”
To crank the engine with the starter,
set this switch to “
”, and then push
the “ ” side of the switch. See page
6-1 for starting instructions prior to
starting the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU41701
The engine trouble warning light will
come on when the key is turned to
“ON” and the start switch is pushed,
but this does not indicate a malfunc-
tion.
EAU12734
Hazar d switch “ ”
With the key in the “ON” or “ ” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazar d li g hts for an
exten d e d len g th of time with the en-
g ine not runnin g , otherwise the b at-
tery may d ischar g e.
EAU47496
Drive mo d e switch “MODE”
WARNING
EWA15341
Do not chan g e the D-mo d e while the
vehicle is movin g .
Using this switch changes the drive
mode to “STD”, “A”, or “B” in the fol-
lowing order:
STD
→
A
→
B
→
STD
The throttle grip must be completely
closed in order to change the drive
mode. (See page 4-10 for an explana-
tion of each drive mode.)
TIP

The mode is set to “STD” by de-
fault. The mode resets to “STD”
when the key is turned to “OFF”.

The selected mode is shown on
the drive mode display. (See page
4-6.)