Operation an
d
important ri
d
in
g
points
6-1
6
EAU15952
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10272
Failure to familiarize yourself with
the controls can lea
d
to loss of con-
trol, which coul
d
cause an acci
d
ent
or injury.
EAU48712
TIP
This model is equipped with:
a lean angle sensor to stop the en-
gine in case of a turnover. In this
case, the display will indicate error
code 30, but this is not a malfunc-
tion. Turn the key to “OFF” and
then to “ON” to clear the error co-
de. Failing to do so will prevent the
engine from starting even though
the engine will crank when push-
ing the start switch.
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAU61932
Startin
g
the en
g
ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-22 for more informa-
tion.
1. Turn the key to “ON” and make
sure that the start/engine stop
switch is set to “
”.
The following warning lights
should come on for a few sec-
onds, then go off.
Coolant temperature warning
light
Engine trouble warning light
Oil pressure warning light (will
come on again after going off
briefly)
NOTICE
ECA21810
If a warnin
g
li
g
ht
d
oes not come
on initially when the key is
turne
d
to “ON”, or if a warnin
g
UBU270E0.book Page 1 Monday, November 14, 2016 8:53 AM