Yamaha FX Nytro FX10X, Инструкция по сборке

Страница: 28 / 84

3-6
CAUTION:
Disconnect the oil level switch coupler before
removing the oil level gauge. Otherwise the
lead can twist and become severed.
5. Remove the oil level gauge
2
, wipe it clean,
insert it back into the filler hole (without screw-
ing it in), and then remove it again to check the
oil level.
NOTE:
The engine oil should be between the “H”
a
and
“L”
b
level marks on the oil level gauge.
6. If the engine oil is below the “L” level mark, add
sufficient oil of the recommended type to raise it
to the “H” level mark.
CAUTION:
• When adding the engine oil, be careful not to
fill above the “H” level mark on the oil level
gauge.
• Make sure that no foreign material enters the
engine oil tank.
7. Insert the oil level gauge into the oil filler hole,
and then tighten it securely.
8. Connect the oil level switch coupler.
9. Install the right side cover. Refer to “SHROUD
AND COVERS”
Recommended engine oil type:
For USA/Canada
YAMALUBE 4-S (0W-30) or
SAE 0W-S 30
For Europe
SAE 0W-30
Recommended engine oil grade:
API service SG type or higher,
JASO standard MA
Quantity:
with oil filter cartridge replace-
ment:
3.2 L (2.82 Imp qt, 3.38 US qt)
without oil filter cartridge replace-
ment:
3.0 L (2.64 Imp qt, 3.17 US qt)
Total amount:
3.9 L (3.43 Imp qt, 4.12 US qt)