Yamaha FL200C, Руководство пользователя

Страница: 56 / 100

Operation
50
EMU31743
Stopping boat
WARNING
EWM01511

Do not use the reverse function to slow
down or stop the boat as it could cause
you to lose control, be ejected, or im-
pact the steering wheel or other parts of
the boat. This could increase the risk of
serious injury. It could also damage the
shift mechanism.

Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The boat is not equipped with a separate
braking system. Water resistance stops it af-
ter the throttle lever is moved back to idle.
The stopping distance varies depending on
gross weight, water surface conditions, and
wind direction.
EMU27822
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU31832
Procedure
1. Turn the main switch to “ ” (off).
2. Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to “
” (off).
EMU27863
Trimming outboard motor
WARNING
EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ON OFF START
ZMU04599
OFF OFF
ON ON
ZMU05833
U6P27AE0.book Page 50 Friday, December 6, 2013 6:17 PM