Yamaha FL200C, Руководство пользователя

Страница: 55 / 100

Operation
49
essary. Consult your Yamaha dealer if
the cause for the low oil pressure alert
cannot be found.
[ECM01832]
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU31722
Stop switches

Confirm that turning the main switch to the
“
” (off) position stops the engine.

Confirm that removing the clip from the en-
gine shut-off switch stops the engine.

Confirm that the engine cannot be started
with the clip removed from the engine shut-
off switch.
EMU31734
Shifting
WARNING
EWM00181
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
NOTICE
ECM01611
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
1.
Pull the neutral interlock trigger up (if
equipped).
2. Move the remote control lever firmly and
crisply forward (for forward gear) or rear-
ward (for reverse gear) about 35° (a de-
tent can be felt).
To shift from in gear (forward/reverse) to neu-
tral
1.
Close the throttle so that the engine
slows to idle speed.
2. After the engine is at idle speed in gear,
move the remote control lever firmly and
crisply to the neutral position.
N
ZMU04588
U6P27AE0.book Page 49 Friday, December 6, 2013 6:17 PM