Operation
56
EMU28061
Shallow water
EMU32851
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
NOTICE
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32922
Procedure for power trim and tilt models
1.
Place the remote control lever in neutral.
2.
Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch.
WARNING! Using the power
trim and tilt switch on the bottom
cowling while the boat is moving or
engine is on could increase the risk of
falling overboard and could distract
the operator, increasing the risk of
collision with another boat or an ob-
stacle.
[EWM01850]
3.
To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
N
ZMU04588
U63P7AE0.book Page 56 Thursday, February 25, 2010 1:14 PM
