Instruments and indicators
29
●
The fuel flow meter displays gallons/hour or
liters/hour according to operator prefer-
ence. Select the desired units of measure-
ment by setting the selector switch on the
back of the gauge during installation.
●
The fuel consumption meter and fuel econ-
omy meter will indicate the same unit of
measurement.
Fuel flow readings are not accurate when the
engine is operating under about 1300 r/min.
As the fuel pump cycles on and off, the display
indicates either no fuel flow or higher flow than
the actual average use.
Dual engine users: the fuel flow meter can
display the fuel flow of either or both engines.
To change the fuel flow display, press the
“
” (set) button repeatedly until the gauge
displays “ ” (for fuel flow to the starboard en-
gine only), “ ” (for fuel flow to the port engine
only), or “
” (for total fuel flow both engines).
EMU36090
Fuel consumption meter / Fuel econo-
my meter / Twin engine speed syn-
chronizer
The display shows either the fuel consump-
tion meter, the fuel economy meter, or the
twin engine synchronizer.
To change the display, press the “
”
(mode) button repeatedly until the indicator on
the face of the gauge points to “
” (fuel con-
sumption meter), “
” (fuel economy
meter), or “
” (twin engine speed syn-
chronizer).
EMU26761
Fuel consumption meter
This gauge displays the total amount of fuel
consumed since the gauge was last reset.
To reset the total fuel consumption meter to
zero, press the “
” (set) and “
” (mode)
buttons at the same time.
EMU26771
Fuel economy
This gauge displays the approximate distance
per liter or gallon when cruising.
1. Selector switch
ZMU01749
ZMU01751
U63P7AE0.book Page 29 Thursday, February 25, 2010 1:14 PM
