Yamaha Fino 125, Руководство пользователя

Страница: 65 / 78

Perio d ic maintenance an d a d justment
7-29
7
EAUN0490
Replacin g a tail/ b rake li g ht
b ul b or a rear turn si g nal li g ht
b ul b
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/ b rake li g ht b ul b
1. Open the seat. (See page 4-8.)
2. Remove panel C. (See page 7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
4. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
5. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
ECAU0091
If a tailli g ht b ul b of d ifferent watta g e
than recommen d e d is use d , it may
cause the b attery to d ischar g e or af-
fect the tailli g ht li g htin g .
6. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
7. Install the panel, and then close
the seat.
Rear turn si g nal li g ht b ul b
1. Open the seat. (See page 4-8.)
2. Remove panel C. (See page 7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise.
4. Remove the burnt-out bulb from
the socket by pulling it out.
5. Insert a new bulb into the socket.
NOTICE
ECAU0081
If a turn si g nal li g ht b ul b of d ifferent
watta g e than recommen d e d is use d ,
the turn si g nal li g ht flashin g may b e
affecte d .
6. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
7. Install the panel, and then close
the seat.
1. Tail/brake light bulb socket
1
1. Rear turn signal light bulb
1
ZAUU1020
UBB9E2E0.book Page 29 Thursday, October 22, 2020 3:53 PM