Maintenance
70
EMU43051
Transporting and storing out-
board motor
WARNING
EWM02620
●
USE CARE when transporting fuel tank,
whether in a boat or car.
●
DO NOT fill fuel container to maximum
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
●
Leaking fuel is a fire hazard. When trans-
porting and storing the outboard motor,
disconnect the fuel line from the out-
board motor to prevent fuel from leak-
ing.
●
Never get under the outboard motor
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
●
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
NOTICE
ECM02440
When storing the outboard motor for pro-
longed time, fuel must be drained from the
fuel tank. The deteriorated fuel could clog
the fuel line causing engine start difficulty
or malfunction.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
●
Disconnect the fuel hose from the fuel joint
on the outboard motor and install the fuel
joint cap.
●
Close the fuel cock on the outboard motor,
and then tighten the built-in fuel tank cap
and its air vent screw.
●
Tighten the portable fuel tank cap and its air
vent screw.
●
Store the portable fuel tank in a well-venti-
lated place.
●
Store the portable fuel tank in a place that is
stable and not exposed to shocks.
When the outboard motor is tilted prolonged
time for mooring or trailering the boat, make
sure to follow the procedure listed below.
●
Disconnect the fuel hose from the fuel joint
on the outboard motor and install the fuel
joint cap.
●
Close the fuel cock on the outboard motor,
and then tighten the built-in fuel tank cap
and its air vent screw.
●
Tighten the portable fuel tank cap and its air
vent screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the tilt
position using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU42901
Transporting/Dismounting the out-
board motor
F2.5A
When transporting or storing the outboard
motor while removed from a boat, keep the
outboard motor in the attitude shown.
U6BV23E0.book Page 70 Tuesday, April 5, 2011 2:38 PM
