Yamaha F30B 2018, Руководство по обслуживанию

Страница: 56 / 348

3-6
Rigging grommet mounting
Installing the shift cable and throttle
cable
Always perform the cable adjustment in ad-
vance, following the procedures in the in-
struction accompanied with remote control
box.
1. Route:
• Shift cable
• Throttle cable
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the cable guide “1” to the grooves
“a” of the shift cable “2” and the throttle ca-
ble “3”, and then route the bottom cowling.
b. Tighten the cable guide bolt “4” to the
specified torque.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Install:
• Shift cable
• Throttle cable
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Fully screw in the shift cable joint “1” to the
shift cable “2”.
b. Move the remote control lever to the N po-
sition.
c. Align the pin “1” with the mark “a” on the
shift bracket “2”.
d. Make a mark “a” on the fully retracted inner
cable, and then make a mark “b” on the ful-
ly extended inner cable.
e. Make a mark “c” in the middle point be-
tween marks “a” and “b”, and then align the
mark “c” with the outer cable edge “d”.
f. Adjust the shift cable joint “1”, and then in-
stall it to the pin “2”.
The shift cable joint must be screwed in 8 .0
mm (0. 3 1 in) or more.
g. Install the clip “3”, and then check that the
shift cable locknut “4” is fully seated on the
shift cable joint “1”.
Cable guide bolt “4”
10 N·m (1.0 kgf·m, 7.4 lb·ft)
1
4
2
3
a
T
R
.
.
2
1
2
1
a
a
a
a
b c
c
d