Yamaha F200B, Руководство по обслуживанию

Страница: 547 / 579

10-6
10
È
703 remote control model
É
704 remote control model
Checking the fuel system
1. Check that the fuel hoses are connected
securely. To check the fuel hose connec-
tions, see “Fuel hose and blowby hose”
(6-1).
NOTICE: This outboard motor is
equipped with a 4-stroke engine.
Never use pre-mixed fuel or 2-stroke
outboard motor oil.
Checking the gear oil level
Do not reuse a gasket, always replace it
with a new one.
1. Place the outboard motor in an upright
position.
2. Remove the check screw 1 , and then
check the gear oil level.
TIP:
If the oil is at the proper level, a small amount
of oil should flow out of the check hole.
3. Install a new gasket
2
and the check
screw
1
, and then tighten the check
screw
1
to the specified torque.
Checking the gear shift and throttle
operation
1. Check that the gear shift operates
smoothly when the remote control lever
is moved from the N position to the F or
R position.
2. Check that the throttle operates smoothly
when the remote control lever is moved
from the F or R position to the fully open
position.
Checking the outboard motor
mounting height
1. Check that the anti-cavitation plate
a
is
aligned with the bottom
b
of the boat. If
the mounting height is too high, cavita-
tion will occur and propulsion will
decrease. Besides, the engine speed will
increase abnormally and cause the
engine to overheat. If the mounting
height is too low, water resistance will
increase, which will decrease engine effi-
ciency and performance.
TIP:
The appropriate mounting height depends on
the combination of the boat and outboard
motor. To determine the appropriate mount-
ing height, test run the outboard motor at dif-
ferent heights.
2. Check that the clamp brackets are
secured using the clamp bolts.
START
ON
OFF
É
2
1
Check screw
1
: 9 N·m (0.9 kgf·m, 6.6 ft·lb)
a
b
Predelivery check