REFERENCE SECTION
Drum Kit V
oice Edit Mode
45
3
Voice (bottom row)
Choose a voice (voice name) categorized in
Type. If the voice name ends with a “
” mark,
that voice is looped.
3
Voice (top row)
Your selection is shown here as a voice number
associated with the voice name in the bottom
row. If the voice number ends with a “*” mark,
that voice is 2-layered and consists of 2 different
sounds.
4
Volume
Set the output volume of the voice. By setting the
volume for each voice, you can balance voices
assigned in the drum kit.
❏
Settings
: 0 – 127
5
Tuning
Adjust the tuning of the chosen voice by
approximately one cent (1/100 semitone).
❏
Settings
: -24.00 – +24.00
[Voice2] Special snare drum settings
Set the special snare drum parameters only when
you have chosen “XtrSnr” for the Type in the
[VOICE1] page. You cannot edit parameters in
this page when any other voice is chosen (“---” is
shown).
1
Shell
Select the shell material of your snare drum.
Mostly, each value indicates the material and the
depth (in inches) of the shell.
❏
Settings
: Mapl1370, MCAbs55, MCVint55, Beech55,
Maple55, Alumin55, Brass35, Brass55, Brass65,
Steel65, Bamboo, FRPSnr
2
Muffle
Specify the muting method for the batter-side
head. You can simulate the muting material using
the following values:
off:
no muting.
tape:
muted using tape.
ring:
muted using a ring material put along the
rim.
❏
Settings
: off, tape, ring
3
Snare
Select the snare sound of your snare drum.
❏
Settings
: warm, crisp, cool, short, punchy, BS, silky,
bright, old, VOX1, VOX2, VOX3, roll, trash
4
Strainer
Adjust the strainer of your snare drum. You can
simulate the strainer setting using the following
values:
off:
the snare is not touching the snare-side head.
loose:
the snare is strained loosely.
mid:
an intermediate setting between loose and
tight.
tight:
the snare is strained tightly.
❏
Settings
: off, loose, mid, tight
5
Balance
Adjust the volume balance between the shell and
snare sounds. As a large positive value is set, the
snare sound becomes loud. As a large negative
value is set, the shell sound becomes loud.
❏
Settings
: -64 – 0 – +63
Shell Muffle Snare Strainer Ballance
Beech55 off warm loose 0
1
4
5
3
2
Содержание DTXTREME
Страница 1: ......
Страница 136: ...String Guitar Percussion Division Yamaha Corporation 2000 Yamaha Corporation Printed in Taiwan ...