Yamaha DTX700, Руководство пользователя

Страница: 12 / 64

Setup
12
DTX700 O w ner’s Man u al
Component Names & Functions
q
[LCD CONTRAST] knob
(page 19)
This kno b is u sed to set the display contrast for opti-
m u m legi b ility.
w
[ ] connector
(page 13)
Use this connector for the po w er adaptor that came
w ith yo u r DTX700.
e
Cord clip
(page 13)
Wrap the po w er adaptor cord aro u nd this clip to pre-
vent accidental u npl u gging d u ring operation.
r
MIDI [IN] and [OUT] connectors
(page 13)
The MIDI [IN] connector is u sed to receive control or
performance data from another MIDI device, s u ch as
an external seq u encer, via a MIDI ca b le. When con-
nected in this w ay, yo u can play the DTX700’s internal
tone generator and control many of its parameters
u sing another MIDI device. Mean w hile, the MIDI [OUT]
connector is u sed to send performance data from the
DTX700 to other devices in the form of MIDI mes-
sages.
t
[AUX IN] (auxiliary input) jack (page 13)
External a u dio signals can b e inp u t via this stereo
mini-jack. Using [AUX IN], yo u can connect a porta b le
m u sic player, a CD player, or another similar device to
play along w ith yo u r favorite t u nes.
y
OUTPUT [L/MONO] and [R] jacks (page 13)
Use these jacks to o u tp u t line-level stereo mixes from
yo u r DTX700. For example, yo u can connect each of
the jacks to the left and right inp u ts of an external ste-
reo amplifier or mixer u sing mono a u dio-jack ca b les.
For mono o u tp u t, u se the [L/MONO] jack only.
u
[PHONES] jack
(page 13)
Use this standard a u dio jack to connect a pair of ste-
reo headphones.
i
Trigger input jacks [
q
SNARE] to [
i
HI-HAT],
and [
!1
]
These trigger-inp u t jacks are u sed to connect stereo-
type pads (t w o- and three-zone). They also s u pport
standard mono-o u tp u t pads. In addition, these trigger-
inp u t jacks are compati b le w ith pad controllers.
o
[HI-HAT CONTROL] jack
This jack is u sed to connect an HH65 Hi-hat Controller
or an RHH135 Real Hi-hat Pad via its control o u tp u t.
!0
Trigger input jack [
o
KICK/
!0
]
This trigger-inp u t jack is u sed to connect mono-type
pads s u ch as the KP65 Kick Pad. If u sing a KP65, f u r-
thermore, yo u can u se the inp u t jack on its rear s u r-
face to connect an additional mono-type pad.
Mean
w hile, yo u co u ld also u se a Y-shaped ca b le (sold
separately) w ith this jack in order to connect a pair of
mono-type pads.
!1
Trigger input jack [
!2
HH-KICK]
This jack is u sed to connect an HH65 Hi-hat Controller
(sold separately) for u se as an alternative kick pad or
as part of a do ub le b ass dr u m config u ration (page 50).
Rear Panel
w e r t u y q
i !1 !0 o