Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
49
5-5. Gain
Using the following procedure, you can set the gain level for
trigger signals output from individual pads. The higher the
gain setting, the louder the sounds produced by light drum-
ming.
1.
While holding the
[KIT]
button, press the
[SONG]
but-
ton to activate Menu Mode.
2.
Press number button
[5]
to select the Trigger Settings
parameter group.
3.
Press number button
[5]
to select the Gain parameter.
4.
Strike a pad to select it.
5.
Enter a new gain level using number buttons
[1]
to
[10/
0]
.
5-6. Minimum Level
When the strength with which you strike a pad is no more
than this level, the pad will not output a trigger signal in
response and no sound will be produced.
1.
While holding the
[KIT]
button, press the
[SONG]
but-
ton to activate Menu Mode.
2.
Press number button
[5]
to select the Trigger Settings
parameter group.
3.
Press number button
[6]
to select the Minimum Level
parameter.
4.
Strike a pad to select it.
5.
Enter a new setting (%) using number buttons
[1]
to
[10/0]
.
6-1. Timer
Using the following procedure, you can set the practice
timer used in the drum module’s Training Mode. The timer
begins counting at the start of a training session, and when
the set time is reached, it automatically ends the session.
1.
While holding the
[KIT]
button, press the
[SONG]
but-
ton to activate Menu Mode.
2.
Press number button
[6]
to select the Training Settings
parameter group.
3.
Press number button
[1]
to select the Timer parameter.
4.
Select your preferred practice time using the corre-
sponding number button (
[1]
to
[10/0]
). The available
settings are as follows.
Steps:
MENU ([KIT] + [SONG])
[5]
[5]
Setting
Setting
1 to 127
Steps:
MENU ([KIT] + [SONG])
[5]
[6]
Setting
Setting
0 to 99 (%)
Setting
Setting
n
Training Settings
Steps:
MENU ([KIT] + [SONG])
[6]
[1]
Setting
Number button
Setting
[1]
Off
[2]
30 seconds
[3]
60 seconds
[4]
90 seconds
[5]
120 seconds
[6]
150 seconds
[7]
180 seconds
[8]
300 seconds
[9]
480 seconds
[10/0]
600 seconds
The practice time set using this parameter applies to the following
types of training only.
• Groove Check
• Rhythm Gate
• Measure Break
• Tempo Up/Down
• Change Up
• Pad Gate
Other types of training are not affected.
Setting
NOTE
Содержание DTX400K
Страница 66: ...DTX400K DTX430K DTX450K Owner s Manual 66 ...