Yamaha DG60FX-112, Руководство пользователя

Страница: 25 / 32

25
To send all USER AREA data (
011
-
933
) plus
Utility settings with the Bulk Out operation.
Press the [TAPE ECHO] button (“
ALL
” will appear
on the display), then press the [STORE] button to
carry out the MIDI Bulk Out.
To send a single USER AREA patch (data) with
the Bulk Out operation.
After pressing the [SPRING] button, select the patch
number you want to send with the bulk out. Just as
in selecting a patch number in the Play Mode, use
the [UP]/[DOWN] buttons or the foot switches to
select the patch.
After selecting a patch, press the [STORE] button
to carry out the MIDI Bulk Out operation with a single
patch.
* After transmitting the data the device will return to the previ-
ous condition, ready to select another patch number.
●
About the MIDI Bulk In
This operation is used to return data stored in an
external MIDI device such as the YAMAHA MDF3,
etc., to the DG60FX-112.
Use a MIDI cable to connect the MIDI OUT jack on
the external MIDI device to the DG60FX-112’s MIDI
IN jack.
When Bulk Out data is sent from the external de-
vice, the DG60FX-112 will receive the bulk data.
* Use the DG60FX-112’s Play Mode to receive MIDI Bulk In
data.
When the MIDI Bulk In is carried out, the con-
tents of the patches in the USER AREA will
be rewritten.
Please make sure any important data is saved
before carrying out the MIDI Bulk In opera-
tion.
■
External Control Settings
Just as in the [External Control Settings] section on
page 21, these settings are used to control the
DG60FX-112’s volume, tone and effect parameters
from a foot controller that is connected to the EXP.
PEDAL jack or a MIDI device that is connected to
the MIDI In jack.
Press the [UTILITY] button then set the Amp Select
switch to DRIVE1 (“
CtL
” will appear on the dis-
play).
●
External Control’s Operating Mode Setting
Press the [COMP] button and use the [UP]/[DOWN]
buttons to select an Operating Mode for the exter-
nal control.
•
GLb
: The external control setting in the Utility
Mode is always available.
•
PrG
: The external control setting that is set in
the patch is available.
•
oFF
: The external control is always OFF.
The following settings for "Set the External
Control Number" through "Set the Parameter’s
Maximum Value" can be set only when the Ex-
ternal Control’s Operating Mode is set to
"
GLb
".
* Refer to the [External Control Settings] section (page 21)
for more information on each of the settings.
●
Set the External Control Number
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set a control number (
1
-
8
).
●
Set the External Controller
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to select the type of controller (
EP
,
1
-
31
,
64
-
95
).
●
Set the Parameter to be Controlled
Press the [PHASER] button and use the [UP]/
[DOWN] buttons to select the parameter to be con-
trolled (
UUH
-).
●
Set the Parameter’s Minimum Value
Press the [ROTARY] button and use the [UP]/
[DOWN] buttons to set the parameter’s minimum
value (the parameter’s value when the controller is
set to its minimum:
0.0
-
10.0
).
Utility Mode