Yamaha DG60FX-112, Руководство пользователя

Страница: 10 / 32

10
Connections
Before making any connections to any of the DG60FX-112’s INPUT and/or OUTPUT jacks,
make sure that the power on the DG60FX-112 and all other devices is turned OFF to pre-
vent electrical shock or damage to the devices.
■
Connecting the Foot Switch Unit
Use the supplied special cable to connect the Foot
Switch Unit to the main unit of the DG60FX-112.
* Never use a cable other than the supplied special cable as it
may result in damage.
1. Connect one end of the special cable to the
FOOT SW terminal on the Rear Panel of the
DG60FX-112. Pay attention to the plug’s orien-
tation when inserting it into the terminal.
* The plugs at either end of the special cable are the same.
■
POWER AMP IN Jack, LINE OUT Jack
●
An external effector can be placed (in a series
circuit) between the LINE OUT jack and POWER
AMP IN jack.
* If the external effector is a monaural input type, use the
DG60FX-112’s L/MONO LINE OUT jack when connecting
the effector.
Special Cable
●
The DG60FX-112’s speaker reproduces the sig-
nal from the “L” LINE OUT jack. By connecting
an external power amp and speaker to the “R”
LINE OUT jack, you can use the external unit in
combination with the DG60FX-112 as a stereo
guitar amp.
* When connecting an external guitar amplifier, if the external
unit is equipped with an effects loop, we recommend con-
necting the DG60FX-112 to the external unit’s EFFECT
RETURN jack. If the unit is not equipped with an effects loop,
connect the DG60FX-112 to the external unit’s INPUT jack
and adjust the volume and tone controls on the external amp
as needed.
DG60FX-112
(L Side)
External Amp
(R Side)
LINE OUT
R
External Effector
2. In the same manner, connect the other end of
the special cable to the terminal on the Rear
Panel of the Foot Switch Unit.