Internal Design of the CP5 & CP50
Left & Right Parts
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
Song Setting Area
TRACK Part
MIC INPUT Part
Settings for All Parts
Settings for All Performances
34
CP5/CP50 Reference Manual
Setting Controllers (Pages 3 to 5)
Edit Sequence
Press the [COMMON] button
Navigate to Page 3, 4, or 5 using the [
L
PAGE] and
[PAGE
R
] buttons
Turn Knobs 1 to 3
Page
On-screen name
(and full name)
Description
Pages
3 to 5
Source
This parameter is used to select the controller to be edited.
Setting values:
CP5 Performances:
PB (Pitch Bend wheel), FC1 (Foot Controller 1), FC2 (Foot Controller 2),
FS (assignable foot switch)
CP50 Performances:
PB (Pitch Bend wheel), FC (Foot Controller), FS (assignable foot switch)
FC1 or FC2 (CP5) / FC (CP50)
Foot controller(s) connected to the FOOT CONTROLLER jack(s)
FS
Foot switch connected to the ASSIGNABLE jack
3
CP5:
L1Dest (LEFT1 Destination)
L2Dest (LEFT2 Destination)
CP50:
LDest (LEFT Destination)
These parameters are used to assign the controllers selected using
Source with a function for the corresponding part.
Setting values:
As follows.
NOTE
If “modFx” is selected as a destination with Source set to “PB”,
“FC1”, “FC2”, or “FC”, you can then use the corresponding
controller to adjust one of the parameters from the Modulation
Effect block up or down with respect to the current setting. For
details on the actual parameter that will be assigned, see the
Modulation Effect block's parameter list in the
Data List
document. Specifically, the parameter marked
in the
Control
field
will be assigned to the controller.
NOTE
If
Source
is set to “FS”, the function assigned as the destination can
be turned on and off by pressing the controller in question. If the
destination is specified as “vibrato”, “modFx”, or “pwrAmp”,
pressing the controller will have the same effect as pressing the
[PRE-AMP], [MOD-FX], or [PWR-AMP] button. For details on how
this will affect the sound, refer to the
Quick Guide
section from the
Owner’s Manual
booklet.
4
CP5:
R1Dest (RIGHT1 Destination)
R2Dest (RIGHT2 Destination)
CP50:
RDest (RIGHT Destination)
5
Mode (Switch Mode)
This parameter is available only when
Source
has been set to “FS”. It is
used to specify whether the controller in question will operate as a
latch-type or momentary-type switch. Latch-type switches remain on or
off after being operated, while momentary-type switches remain on only
while they are being operated.
Setting values:
momentary or latch
Source
Destination
PB (Pitch Bend)
off or modFx (modulation
effect)
FC1 or FC2 (CP5 Foot Control-
ler 1 or 2) / FC (CP50 Foot
Controller)
off, volume, or modFx
FS (assignable foot switch)
off, vibrato, modFx, or
pwrAmp (CP5 only)
