26
Advanced Functions
Playing various musical instrument sounds (Voices)
Turning transpose on or off
Each time you press the [TRANSPOSE] button, transpose turns on or off. When
the lamp is flashing, the function is on. When it is off or the transposition
amount is 0, the lamp does not flash.
This function lets you layer and play two different Voices at the same time. You can layer Voices of two
different categories or two different Voices in the same category, and create a composite Voice of greater
richness and texture.
1.
Call up the Dual mode.
Press two Voice buttons at the same time. The Voice indicators of both
selected Voices will light when the Dual mode is active.
Try playing the keyboard and listen to the resulting sound.
Voice 1/ Voice 2
According to the Voice numbering
priority shown on the right, the
lower value Voice number will be
designated as Voice 1, and the other
Voice as Voice 2.
The Function mode provides access to a number of other Dual mode
functions, such as volume balance setting or octave setting (page 51).
2.
Exit the Dual mode and return to normal play mode.
To return to the normal single-Voice play mode, press any single Voice
button.
NOTE
Audio Song playback cannot be
transposed.
Layering two Voices (Dual mode)
2
1
NOTE
(CLP-470/440/S40
8
/S406)
Dual and Split (page 27) modes
cannot be called up at the same
time.
(CLP-470/440/S40
8
/S406)
[VARIATION] in Dual Mode
The [VARIATION] button’s
indicator will light if the variation is
engaged for either or both of the
Dual mode Voices. While Dual
mode is called up, the
[VARIATION] button can be used
to turn the variation for both
Voices on or off. To turn the
variation on or off for only one of
the Voices, hold the Voice button
for the other Voice and press the
button of the Voice for which you
want to change the variation.
[REVERB] in Dual Mode
An optimum reverb type for the
combination of Voices is assigned
automatically.
[EFFECT] in Dual Mode
Depending on the conditions, one
effect type will take priority over
the other. To change the effect
depth, press the [-/NO] or [+/YES]
button while holding the [EFFECT]
button. This will be applied to
Voice 1 only. The depth can also
be changed in the Function mode
(page 51).
1
2
12
13
14
3
4
5
6
7
8
9
10
11
Voice numbering priority