Yamaha Clavinova CLP-220, Руководство пользователя

Страница: 35 / 50

CLP-220
Keyboard Stand Assembly 35
ENGLISH
3.
Mount A.
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
3-1
Assemble the side panel protection (card-
board) pad, as shown in the illustration.
Then, remove the two backing papers from
the adhesive tape on the protection pad.
3-2
Cover the top of D and E with the side panel
protection pad. Then, fix the protection pad
with the adhesive tape.
3-3
Lower A horizontally while aligning a pin on
the inner side of D and E with a bracket in
the slot on the left and right side of A, then
attach A to D and E securely.
3-4
Remove the side panel protection pad.
4.
Secure A.
4-1
Secure A by tightening the short screws
2
(6
×
16mm) from the front.
5.
Secure B and C.
5-1
Securely tighten the screws on the top of B
that were attached in Step 2-2.
5-2 Securely tighten the screws on C that were
attached in Step 1-3.
6.
Connect the pedal cord.
6-1
Insert the pedal cord plug to the pedal con-
nector from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the
pedal cord.
L
3-3
E
D
A
3-2
Place your hands
at least 10 cm
from either end
of A when
positioning it.
L
A
4-1
A
5-1
5-2
B C
PEDAL
6-1
6-3
6-2
33