Yamaha Clavinova CLP-170, Руководство пользователя

Страница: 113 / 124

CLP-170/150
113
CLP-150: Keyboard Stand Assembly
3.
Fix the main unit.
4.
Connect the pedal cord.
5.
Secure the pedal cord.
6.
Set the voltage selector and connect
the power cord.
Voltage Selector
Before connecting the AC power cord, check the setting of the volt-
age selector which is provided in some areas. To set the selector for
110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver
to rotate the selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage selector is set
at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may
be also provided in some areas to match the pin configuration of
the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage
to the Clavinova or result in improper operation.
CAUTION
Fingers can become pinched between the main unit
and the rear or side panels, be extra careful so as not
to drop the main unit.
CAUTION
Do not hold the keyboard in any position other than
the position shown in the illustration.
R
At least
10cm
Be sure to place your hands at least 10 cm from
either end of the main unit when positioning it.
(1) Center the main unit to produce equal
clearance on the left and right sides.
(2) Use 6
×
16 mm short screws 2
to secure the main unit from the
front.
(2) Attach the cord
holders to the rear
panel as shown,
then clip the cord
into the holders.
PEDAL
(1) Insert the pedal
cord plug to the
pedal connector
from the front.
AC INLET
240
127
110
220