SET UP screen
26
— Reference Guide
Solo Setup page
Make solo settings
[Function]
Make various settings related to the Solo
function.
[Key operation]
• [SETUP] key
→
[F3] (Solo Setup) key
(*1)
• Repeatedly press the [SETUP] key until
the screen shown at the right appears.
*1. In the SET UP screen, the tabs dis-
played at the bottom of the screen are
divided into two groups. If the Solo
Setup tab is not assigned to the [F3]
key when you press the [SETUP] key,
press the [SHIFT] key + [F1] (CHANGE
TAB) key to switch the tabs.
[Mouse operation]
M button
→
SETU button
→
Solo Setup
tab
[Screen functions]
A
STATUS
Turn on one of the following two buttons to
select the operating mode of the Solo function.
●
RECORDING SOLO
If this button is on, the solo signal will be output
via the dedicated SOLO bus to the MONITOR
OUT jacks/PHONES jack. (The output of the
stereo bus and buses 1–8 will not be affected.)
You can also monitor channels that are not
assigned to the stereo bus or to buses 1–8, or
channels whose [ON] key is off.
●
MIXDOWN SOLO
If this button is on, the solo signal will be output
via the stereo bus to the MONITOR OUT jacks/
PHONES jack. When the Solo function is turned
on, only the channel(s) being soloed will be
sent to the stereo bus, and the remaining chan-
nels will be muted. It is not possible to monitor
channels that are not assigned to the stereo bus.
B
LISTEN
When RECORDING SOLO is selected for
1
,
you can select one of the following two loca-
tions from which the signal will be sent from
each channel to the SOLO bus.
●
PRE FADER
The pre-fader signal will be sent to the SOLO
bus. Since the pan setting of the channel will
have no effect, the signal being monitored from
the MONITOR OUT jacks/PHONES jack will be
monaural.
●
AFTER FADER
The signal after passing through fader and pan
will be sent to the SOLO bus. The pan and fader
settings of each channel will affect the signal
that is monitored by the MONITOR OUT jacks/
PHONES jack.
C
SEL MODE (select mode)
Select one of the following two ways by which
the monitored signal will be selected when the
Solo function is on.
1
2
3
4
5