Setting the layout of the presence speakers
Selects a presence layout when presence speakers are used. This setting facilitates
the optimization of the sound field effect.
Setup menu
“Speaker” > “Configuration” > “Layout”
Settings
Front Height
Select this option when presence speakers are installed on the front wall.
Overhead
Select this option when presence speakers are installed to the ceiling.
Dolby Enabled SP
Select this option when using the Dolby Enabled speakers as the
presence speakers.
NOTE
▪ This setting is not available when “Presence” is set to “None”. For details on “Presence” in the “Setup”
menu, see the following:
– “Setting the use of presence speakers and their size” (p.96)
▪ For details on the layouts of the presence speakers, see the following:
– “Presence speaker layout” (p.147)
Setting the crossover frequency of the low-frequency
components
Sets the lower limit of the low-frequency components that can be output from a
speaker whose size is set to “Small”. A frequency sound lower than the specified value
will be produced from the subwoofer or front speakers.
Setup menu
“Speaker” > “Configuration” > “Crossover”
Settings
40 Hz, 60 Hz, 80 Hz, 90 Hz, 100 Hz, 110 Hz, 120 Hz, 160 Hz, 200 Hz
NOTE
If the volume and crossover frequency are adjustable on your subwoofer, set the volume to half and
crossover frequency to maximum.
Setting the phase of the subwoofer
Sets the phase of the subwoofer. When the bass sound is lacking or unclear, switch
the subwoofer phase.
Setup menu
“Speaker” > “Configuration” > “Subwoofer Phase”
Settings
Normal
Does not reverse the subwoofer phase.
Reverse
Reverses the subwoofer phase.
NOTE
This setting is not available when “Subwoofer” is set to “None”. For details on “Subwoofer” in the “Setup”
menu, see the following:
▪ “Setting the use of a subwoofer” (p.94)
Setting the use of Extra Bass
Enables/disables Extra Bass. When Extra Bass is enabled, you can enjoy enhanced
bass sounds, regardless of the size of the front speakers and the presence or
absence of the subwoofer.
Setup menu
“Speaker” > “Configuration” > “Extra Bass”
Settings
Off
Disables Extra Bass.
On
Enables Extra Bass.
NOTE
You can also use BASS on the remote control to enable/disable Extra Bass.
En
97