Setting the version of HDCP used on the HDMI input
jacks
Selects the HDCP version of the HDMI input jacks for watching 4K video content.
Setup menu
“HDMI” > “HDCP Version”
Input sources
HDMI 1–4
Settings
Auto
Automatically sets the version of HDCP according to content.
1.4
Sets the version of HDCP to always be 1.4.
Setting the audio jack used for TV audio input
Selects an audio input jack of the unit to be used for TV audio input when “HDMI
Control” is set to “On”. The unit’s input source automatically switches to TV audio when
the TV input is switched to its built-in tuner.
NOTE
For details on “HDMI Control” in the “Setup” menu, see the following:
▪ “Setting the use of HDMI Control” (p.100)
Setup menu
“HDMI” > “TV Audio Input”
Settings
AV 1–3, AUDIO 1–3
NOTE
When using ARC to input TV audio to the unit, the input jacks selected here will be used for TV Audio Input.
Linking the standby modes of the unit and the TV
Select whether to use HDMI control to link the unit's standby mode to the TV's power
when “HDMI Control” is set to “On”.
NOTE
For details on “HDMI Control” in the “Setup” menu, see the following:
▪ “Setting the use of HDMI Control” (p.100)
Setup menu
“HDMI” > “Standby Sync”
Settings
Off
Does not set the unit to standby mode when the TV is turned off.
On
Sets the unit to standby mode when the TV is turned off.
Auto
Sets the unit to standby mode when the TV is turned off only when the unit
is receiving TV audio or HDMI signals.
Setting the use of ARC
Select whether to output TV audio to the speakers connected to the unit when “HDMI
Control” is set to “On”.
NOTE
For details on “HDMI Control” in the “Setup” menu, see the following:
▪ “Setting the use of HDMI Control” (p.100)
Setup menu
“HDMI” > “ARC”
Settings
Off
Disables ARC.
On
Enables ARC.
NOTE
You do not need to change this setting normally. In case noises are produced from the speakers connected
to the unit because TV audio signals input to the unit via ARC are not supported by the unit, set “ARC” to “Off”
and use the TV’s speakers.
En
101