Yamaha AVENTAGE RX-A670, Руководство пользователя

Страница: 37 / 140

Error messages
If any error message is displayed during the measurement, resolve the problem and
perform YPAO again.
Error message
TV screen
ENHANCER
LINK
ECO
MASTER
OUT 2 -R es
Hi YPAO VOL. A - DRC
SLEEP
STEREO
PARTY
TUNED ZONE
3 B 2 A
FPR
SBL SB SBR
FPL
MUTE VIRTUAL
E-5:NOISY
VOL.
SL SW SR
E-5:NOISY
Front display
n
Procedure to handle errors
1
Check the content of error message and press ENTER.
2
Use the cursor keys ( e / r ) to select the desired operation.
To exit the YPAO measurement:
1
Select “EXIT” and press ENTER.
2
Use the cursor keys (
q
/
w
) to select “Exit” and press ENTER.
3
Disconnect the YPAO microphone from the unit.
To retry the YPAO measurement from beginning:
1
Select “RETRY” and press ENTER.
To proceed with the current YPAO measurement (for E-5 and E-9
only):
1
Select “PROCEED” and press ENTER.
Error message Cause Remedy
E-1:No Front SP
(E-1:NO FRNT SP)
Front speakers are not
detected.
Exit YPAO, turn off the unit, and then
check the speaker connections.
E-2:No Sur. SP
(E-2:NO SUR SP)
One of the surround
speakers cannot be
detected.
E-3:No F.PRNS SP
(E-3:NO FPR SP)
One of the presence
speakers cannot be
detected.
E-4:SBR → SBL
(E-4:SBR
→
SBL)
A surround back speaker is
connected to the R side
only.
When using only one surround back
speaker, you need to connect it to the
SINGLE jack (L side). Exit YPAO, turn off
the unit, and then reconnect the speaker.
E-5:Noisy
(E-5:NOISY)
The noise is too loud.
Keep the room quiet and retry YPAO. If
you select “PROCEED”, YPAO takes the
measurement again and ignores any
noise detected.
E-6:Check Sur.
(E-6:CHECK SUR)
Surround back speakers are
connected, but no surround
speakers are connected.
Surround speakers need to be
connected in order to use surround back
speakers. Exit YPAO, turn off the unit,
and then reconnect the speakers.
E-7:No MIC
(E-7:NO MIC)
The YPAO microphone has
been removed. Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO.
E-8:No Signal
(E-8:NO SIGNAL)
The YPAO microphone
cannot detect test tones.
Connect the YPAO microphone to the
YPAO MIC jack firmly and retry YPAO. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.
E-9:User Cancel
(E-9:CANCEL)
The measurement has been
canceled.
Retry or exit YPAO as necessary.
E-10:Internal Err.
(E-10:INTERNAL)
An internal error has
occurred.
Exit YPAO, and turn off and on the unit. If
this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or
service center.
Note
Texts in parentheses denote indicators on the front display.
En
37