En
40
5
Connecting other devices
Connect a device compatible with the trigger function.
Connecting a device compatible with the trigger
function
The trigger function can control an external device in conjunction with operating the unit (such
as powering on/off and input selection). If you have a Yamaha subwoofer that supports a
system connection or a device with a trigger input jack, you can use the trigger function by
connecting the external device to one of the TRIGGER OUT jacks with a monaural mini-plug
cable.
X
You can configure the trigger function settings in “Trigger Output1” and “Trigger Output2” (p.138) in the “Setup”
menu.
6
Connecting the power cable
Before connecting the power cable (Brazil and General models only)
Set the switch position of VOLTAGE SELECTOR according to your local voltage. Voltages are
AC 110–120/220–240 V, 50/60 Hz.
Y
Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC wall outlet.
Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a potential fire hazard.
After all the connections are complete, connect the supplied power cable to the unit and then
to an AC wall outlet.
HDMI
3
AV 4
(HDCP2.2)
AV 5
AV 6
AV 7
IN
OUT
REMOTE
1
2
SPEAKERS
CENTER
FRONT
SURROUND BACK
F.PRESENCE
R
R
R
L
L
L
ZONE 2
SINGLE
ZONE 2/BI-AMP
E OUT
SUBWOOFER
CENTER
ROUND
SUR. BACK
(SINGLE)
EXTRA SP1
EXTRA SP2
RS-232C
TRIGGER
OUT
1
2
12V
0.1A
MAX. TOTAL
NETWORK
( 3 NET )
TRIGGER
OUT
1
2
12V
0.1A
MAX. TOTAL
The unit (rear)
TRIGGER OUT 1-2 jacks
System connector
jack
Yamaha subwoofer that
supports a system connection
AV 7
IN
OUT
REMOTE
AC IN
ERS
CENTER
FRONT
NCE
R
L
L
-AMP
SP1
RS-232C
GGER
OUT
.1A
TAL
NETWORK
( 3 NET )
VOLTAGE SELECTOR
220V-
240V
110V-
120V
The unit (rear)
VOLTAGE SELECTOR
OUT
OTE
AC IN
CENTER
FRONT
R
L
RS-232C
NETWORK
( 3 NET )
To an AC wall outlet
The unit (rear)
