Yamaha Arius YDP-S51, Руководство пользователя, Страница: 29 / 37

YDP-S51 Owner’s Manual
Appendix
29
E
NGLISH
2-4
Securely tighten the screws on the top of B that
were attached in Step
2-1
.
3
Secure C.
3-1
Securely tighten the screws on C that were
attached in Step
1-3
.
3-2
Attach the caps (
6
) to the head of the screws.
4
Mount A.
5
Secure A.
5-1
Adjust the position of A so that the left and right
ends of A will project beyond D and E equally
when seen from the front.
5-2
Secure A by tightening the four short screws (
3
)
(6 x 16 mm) from the bottom.
6
Connect the pedal cord.
6-1
Insert the pedal cord plug to the [TO PEDAL] jack
from the rear.
6-2
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3
Use a vinyl tie to take up any slack in the pedal
cord.
2-1, 2-4
2-3
D
E
B
2-2
2-2
Secure the anti-fall brackets using the screws.
C
B
3-2
3-1
D
D
A
D E B
Be sure to place your hands at least 10 cm from
either end of
A
when positioning it.
At least 10 cm
Align the dowels on D and E with the corresponding
holes on the bottom of
A
.
At least 10 cm
CAUTION
• Be careful not to pinch your fingers or drop the unit.
• Do not hold the keyboard in any position other than
the position shown in the illustration.
Insert the pedal cord securely until the metal part of the
cord plug disappears from view.
Otherwise, the pedal may not function properly.
5-1
5-2
A
A
Projection of A
6-1
6-2
6-3
Insert the cord all the way
until the metal part of the plug
disappears from view.