108
Care and storage
Post-operation care
Flushing the cooling system
Cooling system flushing is essential to pre-
vent the cooling system from clogging up with
salt, sand, or dirt.
(1) Connect the garden hose adapter to a
garden hose.
1
Garden hose adapter
(2) Loosen the flush hose connector cap and
remove it. Insert the garden hose adapter
into the flush hose connector by pushing
and twisting it until it is securely connect-
ed.
1
Flush hose connector
2
Flush hose connector cap
3
Garden hose adapter
(3) Connect the garden hose to a water tap.
(4) Make sure that the area around the boat
is clear, and then start the engine. Imme-
diately after the engine starts, fully turn
the water supply on so that water flows
out continually from the jet thrust nozzle
and cooling water pilot outlet.
NOTICE:
Never turn on the water before starting
the engine. The water could flow back
through the muffler into the crankcase
causing severe engine damage. Be
sure to turn on the water immediately
after starting the engine to prevent en-
gine overheating.
(5) Run the engine at a fast idle for 3 to 5
minutes. If the engine stops while flush-
ing, turn the water supply off immediately
and perform the procedure again from
step 4.
(6) Turn off the water supply, and then drain
residual water from the exhaust system
by alternately pushing the remote control
lever up to half throttle and back to idle for
10 to 15 seconds.
(7) Stop the engine.
NOTICE:
Never have
the water on when the engine is not
running. The water could flow back
through the muffler into the crankcase
causing severe engine damage. Do
not run the engine for more than 15
seconds after the water supply has
been turned off to avoid engine over-
heating.
(8) Remove the garden hose adapter.
(9) Install and tighten the cap securely.
1
1
2
3
SportsBoat_F4B10.book Page 108 Thursday, June 2, 2016 10:08 AM
Downloaded from
