Instrument operation
53
Drive control screen
This screen can be used to set a target speed
for the boat, or increase the set speed.
To activate the drive control:
(1) Tap the tab you want to set.
(2) Tap the target speed.
(3) To set the speed, tap each digit and
scroll up or down, and then tap the
“Back” button.
(4) Tap the desired acceleration profile.
(5) Tap the desired ballast level.
(6) Tap the “Port” button or “Stbd” button of
“SURFPOINTE”.
(7) Tap “
” to deploy, tap “
” to stow.
(8) Tap the “Set” button, and then tap the
“Save” button.
(9) Select the characters you want to set,
tap the “Save” button.
(10) After setting the preceding items, tap the
“Set” button.
(11) Move the remote control levers to the ful-
ly open position.
TIP:
If the remote control levers are moved
slowly to the fully open position, the boat
may not accelerate according to the select-
ed acceleration profile or reach the set tar-
get speed.
If the single lever mode is activated, move
only the remote control lever for the port
engine to the fully open position. (See page
47 for information on the single lever mode
button.)
Boat speed is limited to 15 mph (24 km/h)
when deploying WakeBooster.
A warning message is displayed on the
multi-function display when overcurrent
occurs. The button name on the side where
overcurrent has occurred turns red.
255XD: While the DRiVE mode is activated,
the drive control mode cannot be used.
To deactivate the drive control:
(1) Return the remote control levers to the
neutral position.
(2) Tap the “CANCEL” button.
Save
Set
Target Speed
WKS
WKB
Acceleration
21.0
Fast
Ballast
0
0
0
Port
Stbd
8
9
0
1
SportsBoat_F5K10.book Page 53 Tuesday, September 8, 2020 11:29 AM
Downloaded from
