Yamaha 210FSH SPORT 2022, Руководство оператора, Страница: 98 / 146

Pre-operation checks
91
1 Dipstick
2 Maximum level mark
3 Minimum level mark
Battery check
Make sure that the battery terminals are not
damaged and that the battery leads are con-
nected properly.
WARNING! The battery
must always be fully charged and in good
condition. Loss of battery power may
leave you stranded. Never operate the
boat if the battery does not have sufficient
power to start the engines or if it shows
any other signs of decreased power.
1 Negative (–) battery terminal: Black lead
2 Positive (+) battery terminal: Red lead
Bilge water check
Make sure that no bilge water has collected in
the engine compartment. If bilge water has
collected in the engine compartment, drain it.
(See page 81 for information on draining the
bilge water.)
Drain plug check
Loosen the drain plug and remove it, and
then make sure that the plug and the O-ring
on the hull drain plug is not damaged and that
there is no foreign material on the threads or
the O-ring on the hull drain plug.
NOTICE:
Before installing the drain plug, clean the
drain plug threads and the O-ring on the
hull drain plug to remove any foreign ma-
terials, such as dirt or sand. Otherwise, the
drain plug could be damaged, allowing
water to enter the engine compartment.
Make sure that the drain plug is tightened
securely before launching the boat. Other-
wise, water may flood the boat and cause
it to submerge.
Securely install the drain plug by tightening it
until it stop.
1 Hull drain plug
2 1 3
1
2
1
1
SportsBoat_F4A14.book Page 91 Monday, May 17, 2021 1:01 PM