Yamaha 2016 Grizzly yfm700gplg, Руководство по обслуживанию

Страница: 347 / 474

REAR CONSTANT VELOCITY SHAFT ASSEMBLIES, FINAL
DRIVE ASSEMBLY AND REAR DRIVE SHAFT
8-26
If “-01” is stamped on the final drive case,
“d” = 100 - 0.01
= 99.99
Therefore, “A” is 0.58.
“A” = 55 + (67.75 - 22.18) - 99.99
= 0.58
Round off the hundredth digit and select the
appropriate shim(s).
In the example above, the calculated number
is 0.58. The chart instructs you to round off 8
to 10 at the hundredth place. Thus, the shim
thickness is 0.60 mm (0.024 in).
Shims are supplied in the following thickness-
es.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
EBS30412
SELECTING THE FINAL DRIVEN PINION
GEAR SHIM (FINAL DRIVE CASE SIDE) AND
THRUST WASHER
1. Select:
• Final driven pinion gear shim (final drive case
side) “1”
• Thrust washer “2”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. To find the final driven pinion gear shim (final
drive case side) and thrust washer thickness
“B”, use the following formula.
“e” = a numeral (usually a decimal number)
on the final drive case either added to or sub-
tracted from “71.6”
“f” = a numeral (usually a decimal number) on
the final driven pinion gear either added to or
subtracted from “51.0”
“g” = a numeral (usually a decimal number)
on the final driven pinion gear either added to
or subtracted from “24.0”
“h” = 49.8
Example:
If “-03” is stamped on the final drive case,
“e” = 71.6 - 0.03
= 71.57
Hundredth Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Final drive pinion gear shims
Thickness (mm)
0.25 0.30 0.35 0.40 0.45 0.50
Final driven pinion gear shim (final drive case
side) and thrust washer thickness
“B” = “h” - (“e” - “f” + “g”)
d
B
h
1
2
g
f
e