PERIODIC MAINTENANCE AND ADJUSTMENT
7-28
7
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed.
NOTICE:
If the
breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas ex-
pelled from the battery, the
frame could suffer structural
and external damages.
[ECA10601]
EAU23601
Replacing the fuses
The main fuse and the signaling sys-
tem fuse holders are located under the
rider seat. (See page 4-9.)
If a fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
3. Turn the key to “ON” and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
1. Main fuse
2. Spare main fuse
3. Signaling system fuse
Specified fuses:
Main fuse:
20.0 A
Signaling system fuse:
10.0 A
U2UJ26E0.book Page 28 Thursday, May 22, 2008 10:21 AM
