How it works
12
03D Video Edit Suite Software—Owner’s Manual
How it works
Channel level adjustments are performed using the channel fader. Crossfades are performed
by the ESAM fader, which appears after the channel fader. The input level is controlled by
the INPUT LEVEL ADJUST control. Both controls are shown in the following illustration.
When the TO EDITOR parameter is set to ENABLE and the 03D is being remotely controlled
by an editor, the channel send level is controlled by the CH fader and ESAM fader. ESAM
faders on channels specified using the FROM command are set to nominal (0 dB). ESAM
faders on channels specified using the TO command are set to the LIMIT LEVEL (usually
minus infinity). After a crossfade, FROM command channels are set to the LIMIT LEVEL,
while TO command channels are set to nominal (0 dB).
When the TO EDITOR parameter is set to DISABLE, the 03D operates as normal (i.e.,
ESAM II commands are ignored). Likewise, a channel in Local mode (i.e., the LOCAL
ON/OFF switch in the ON position) operates as normal, ignoring ESAM II commands.
Local mode is engaged using the [SEL] buttons, but works only when the CH 1–16 or
17–24/Stin pages are displayed. The following illustration shows a channel in Local mode
(or with the TO EDITOR parameter set to DISABLE).
Operating Notes
The editor should be configured so that the recording machine can be monitored. Typically,
the editor will be set to EE mode (Electric-to-Electric).
When the 03D’s output delay is used, it functions as a predelay and the sound will not be
synchronized with the video.
When input channels or bus outputs are configured as stereo pairs, set the corresponding
pan controls hard left and hard right (note there is a 3 dB signal gain in this condition).
To output digital bus signals via the ST DIGITAL OUT connection, use the BUS TO ST func-
tion.
ON
ON
OFF
To AUX
(post)
To AUX
(pre)
CH Fader
INPUT LEVEL ADJUST
& ADJUST ON/OFF
Dynamics
4Band
PEQ
Delay
ATT
Input channels 1–24
PAN
ON
OFF
ESAM FADER
& LOCAL ON/OFF
ON
ON
OFF
To AUX
(post)
To AUX
(pre)
CH Fader
INPUT LEVEL ADJUST
& ADJUST ON/OFF
Dynamics
4Band
PEQ
Delay
ATT
Input channels 1–24
PAN
ON
OFF
ESAM FADER
& LOCAL ON/OFF
