28
Overview of the 01X
01X Owner’s Manual
Before Using
Basics Section
Appendix
Getting Started
Reference
Input channel
●
Input channels 1 through 8
These are monaural input channels used mainly for input
of microphones or line-level instruments. The signals that
are input to input channels 1 through 8 pass through an
attenuator, phase switch, 4-band EQ, and dynamics proces-
sor, and are sent to the stereo bus, AUX buses 1 through 4
and Rec bus. Input channels 1 through 8 also have a direct
output (DIRECT OUT), which allows them to be sent
directly from mLAN outputs.
●
Input channels 9 through 24 (mL1 through mL16)
These are input channels for the signal from mLAN IN.
Each of these channels is structured the same as the input
channels. When the 01X is set to 88.2kHz (Macintosh
only)/96kHz operation, mLAN input (from computer to
the 01X) is limited to 8 channels (9-16: mL1-mL8).
• Faders and most parameters of adjacent odd-even channels are
linked for stereo operation (page 102).
INPUT 1(...8)
RECBUS (BUS) L
RECBUS (BUS) R
STEREO (STEREO BUS) L
STEREO (STEREO BUS) R
AUX 1
AUX 2
AUX 3 (FX1)
AUX 4 (FX2)
AUX
PAN
LEVEL
PRE/POST
ON
Mono in X 8
ON
AUX
PAN
LEVEL
PRE/POST
ON
Mono in X 16
(96kHz/88.2kHz: X 8)
ATT
DIRECT
OUT1(...8)
INPUT 9(...24
*1
) (mL1-mL16
*2
)
4BAND EQ
4BAND EQ
DY-
NAMICS
ON
INSERT
INSERT
ATT
DY-
NAMICS
DIRECT
OUT9(...24
*1
)
INPUT
SELECT (INPUT PATCH)
mLAN IN
1-16
*2
mLAN INPUT
IEEE 1394
16
*2
2
mLAN IN
METER
METER
(Gain Reduction)
(Gain Reduction)
*1 Wordclock 96kHz/88.2kHz : 16
*2 Wordclock 96kHz/88.2kHz : 8
*3 Studio Manager only
(to MONITOR CASCADE)
mLAN STEREO IN
(MONITOR IN)
METER
*3
METER
*3
●
01X Channel Module
The included “01X Channel Module” is a special plug-in
effect that reproduces the Dynamics and four-band EQ
processing of these input channels using the process-
ing power of your computer (refer to the separate Instal-
lation Guide). You can use the 01X Channel Module on
your DAW independently from the 01X. For example
when recording, you can apply Dynamics and EQ to the
01X’s monitor sound only and record dry to the DAW,
then play back the track, processing it with the 01X
Channel Module as needed — all without the 01X.
(Refer to the “DIRECT OUT POSITION” on page 91
and the 01X Channel Module PDF manual.)
