Yale VERACITOR GCC030VX, Руководство по эксплуатации

Страница: 113 / 206

3. Using a lift truck or a lifting device that can be attached
to the mast (I.E. come-a-long), raise the carriage and forks
approximately 30 cm (12 in.) from surface. Install a chain
around a mast crossmember and the carriage, to prevent
carriage and mast channels from moving.
4. If another lift truck is used to tow the disabled lift truck,
that lift truck must have an equal or larger capacity than the
disabled lift truck. Install approximately 1/2 of a capacity
load on the forks of the lift truck that is being used to tow
the disabled lift truck. This 1/2 capacity load will increase
the traction of the lift truck. Keep the load as low as possi-
ble.
5. Use a towing link made of steel that fastens to the tow
pins in the counterweights of both lift trucks.
How to Put a Lift Truck on Blocks
WARNING
The lift truck must be put on blocks for some types of
maintenance and repair. The removal of the following
assemblies will cause large changes in the center of
gravity: mast, drive axle, engine and transmission, and
the counterweight. When the lift truck is put on blocks,
put additional blocks in the following positions to
maintain stability:
1. Before removing the mast and drive axle, put
blocks under the counterweight so that the lift
truck cannot fall backward.
2. Before removing the counterweight, put blocks
under the mast assembly so that the lift truck can-
not fall forward.
The surface must be solid, even, and level when the lift
truck is put on blocks. Make sure that any blocks used
to support the lift truck are solid, one piece units.
NOTE: Some lift trucks have lifting eyes. These lifting eyes
can be used to raise the lift truck so that blocks can be
installed.
How to Raise the Drive Tires
(See Figure 17)
1. Put blocks on each side (front and back) of the steering
tires to prevent movement of the lift truck.
2. Put the mast in a vertical position. Put a block under
each outer mast channel.
Maintenance
111