1032606B - 1/4
60” Tracks with Bolts
power drill
1/8” drill bit
1/4” drill bit
1/8” Allen wrench
TOOLS REQUIRED:
Align tracks to
each other and
position track ends
equal distance
from rear of shell.
Using a marker pen,
outline alternate holes
through the track.
Begin with first or last
hole, and skip every
other hole.
CAUTION: Track base can slide.
Be sure it is aligned to the track!
FOLLOW THE DRILLING DIAGRAM:
Remove track from shell.
NEVER DRILL
THROUGH TRACK!
Drill 1/8” pilot holes
in center of marks.
Drill 1/4” into
pilot holes.
Carefully blow
away debris.
Due to manufacturing variances, shell thickness can differ considerably.
You may need to obtain longer bolts from your local hardware store.
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY
OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR,
CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR,
AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED
WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS
AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE
INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS A
QUALIFIED GARAGE OR AUTO BODY SHOP.
Part #1032606 Rev.B