2
II. Installation For Arduino Smart Car
Accessory Introduction
M3*8mm Copper
Pillar*7
M3*40mm Copper Pillar*2
M3*4mm Copper
Pillar*4
Fixing Support*4
Need to take away from the two
sides of the car chassis center.
M3 Nut*6
M3*8mm
Screw *2
M3*6mm
Screw*2
M3*30mm
Screw*4
Self-tapping
Screw*2
Small Screw*1
NOTE: The self-tapping screws and small screw are put in the servo accessory bag.
2.1 Installation for Servo
Design Sketch (After Installation)
Installation Instruction: Pass the servo through the lower fixing plate and fix it with self-tapping
screws. The ultrasonic fixing plate is installed on the servo and fixed with small screws.
Small Screw
Self-tapping
Screw
