Page 3
VL-1000 Operating Manual
Installation
FT-920/VL-1000
FT-1000MP/FT-650/VL-1000
nected to the INPUT 1/PTT 1/ALC 1 jacks, and
that all cables from exciter #2 are connected
to the INPUT 2/PTT 2/ALC 2 jacks. When us-
ing a B
AND
D
ATA
cable for interconnection, you
do not need the PTT cable for the correspond-
ing exciter, as the T/R control signal will be
made via the B
AND
D
ATA
cable.
ceiver, a B
AND
D
ATA
cable may be con-
nected which provides automatic band
change and T/R control (thus eliminating
the need for cable (B) above), and +48 V
DC supply voltage On/Off control (if the
REMOTE switch on the rear panel of the
VL-1000 is set to the ON position).
Typical installation diagrams are shown
below. When two exciters are utilized, be cer-
tain that all the cables from exciter #1 are con-