3
Rear Panel
Ground
+5V
Board
standoffs
go here
Pads already filled with solder.
1. Strip 3/16" and tin.
2. Leave insulation on.
Hold with pliers.
3. Touch with soldering
iron and push 1/8" of wire
through the opening in the
pad.
INSTRUCTIONS FOR THE FT-1000MP MARK V AND MARK V FIELD
The male connector used in the FT-1000MP to power the Inrad IF mod has been
left off of the Mark V audio board. In order to power the Inrad mod, two # 22 wires, each
about 1 " long, must be inserted into the pad holes as shown.
-These wires should be formed to stand straight and vertical after installation.
-The wire insullation should be removed after soldering.
-Next the plastic board standoffs should be inserted into the holes provided.
-Then the Inrad mod can be lowered in place so the #22 wires go into the proper holes in the
mod connector. No soldering is required, as the wires are acting as connector pins.
-After the mod is in place the excess #22 wire should be trimmed off.
Note: Use care that the wires are not pushed too far through the pad holes, as they
may contact the chassis and short the +5 volts.
PARTS LIST
Assembled IF Mod (Inrad 105)
Coax cable 8”
Board mounts with nuts
0.047 uF Mylar capacitor
2” #22 insulated solid wire
International Radio © 2005. Modifications done at your own risk; seek help if you are not qualified. International Radio
Corp. assumes no responsibility for any damages or injuries resulting from improper installation of this modification kit.
Содержание Mark-V FT-1000MP
Страница 4: ...4...