Yaesu FTM-500DR, Руководство для продвинутых пользователей

Страница: 32 / 74

32
Transmitting GPS location information
The GPS position data (latitude/longitude) of this station can be output from the serial
DATA jack on the rear of the transceiver.
1. Press and hold the
FUNC knob

[ 69 COM PORT ]

Press the FUNC knob.
2. Rotate the FUNC knob to select [ SPEED ] then press the FUNC knob.
3. Rotate the FUNC knob to select the desired communication speed then press the
FUNC knob.
The setting changes in the following order:
4800bps

9600bps

19200bps

38400bps

57600bps
Factory default value: 9600bps
4. Press the FUNC knob.
5. Rotate the FUNC knob to select [ OUTPUT ] then press the FUNC knob.
6. Rotate the FUNC knob to select “ GPS OUT ” then press the FUNC knob.
The setting changes in the following order:
OFF

GPS OUT

PACKET

WAYPOINT
Factory default value: OFF
7. Press the DIAL knob, SUB DIAL knob or PTT switch to finish the setting and return
to the original screen.
Transmits the location information data. The location data is output to the computer at
about one second intervals.
An operating software using NMEA-0183 standard GGA and RMC sentence is required to
use the position information.