Yaesu FTM-3200DE, Руководство для продвинутых пользователей

Страница: 19 / 35

19
Scanning
FTM-3200DR/DE Advance Manual
Programmable Memory Scan (PMS)
The FTM-3200DR can be set to tune or scan only the frequencies between user-defined
lower and band limits.
Example: Set up a PMS channel by registering a lower frequency of 144.300 MHz, and
an upper frequency of 148.000 MHz to the L1/U1 memory channels.
Registering to the programmable memory channels
1. In the VFO mode, select the desired lower-limit scan frequency (144.300 MHz).
2. Press and hold the [
V/M
(
MW
)] key for one
second.
A memory number will appear in the bottom
right corner of the display.
3. Within five seconds of pressing the
[
V/M
(
MW
)] key, rotate the
DIAL knob to se-
lect “L1”.
VOL
DIAL
SQL
TXPO D W M W
SETUP
REV D/A V / M M H z
Note: While operating in the Memory Storage mode, the keypad of the MH-48A6JA
Microphone may be used to enter the memory channel number directly.
To do this, enter the desired Channel Number (see table below) on the keypad
and then press the [
#
] key.
To enter Memory Channel “ L1 ”, press [ 2
]
à
[ 0
]
à
[ 1
]
à
[ #
]
To enter Memory Channel “ U0 ”, press [ 2
]
à
[ 2
]
à
[ 0
]
à
[ #
]
L1 201 L3 205 L5 209 L7 213 L9 217
U1 202 U3 206 U5 210 U7 214 U9 218
L2 203 L4 207 L6 211 L8 215 L0 219
U2 204 U4 208 U6 212 U8 216 U0 220
4. Press the [ V/M
(
MW
)] key again, momentarily, to store the displayed data into the
memory channel (L1).
5. Select the desired upper-limit scanning frequency (148.000 MHz).
6.
Within five seconds of pressing the
[
V/M
(
MW
)] key, rotate the
DIAL knob to se-
lect “U1”.
7. Press the [
V/M
(
MW
)] key again, momentar-
ily, to store the displayed data into the mem-
ory channel (U1).