13
9. Rotate the
DIAL
knob to select the
TX CODE 1
of the
codes from 01 to 50.
10. Press the
DIAL
knob or the [
BACK
] key.
11. Rotate the
DIAL
knob to select [
TX CODE 2
] then
press the
DIAL
knob.
12. Rotate the
DIAL
knob to select the
TX CODE 2
of the
codes from 01 to 50.
The same code cannot be used for
TX CODE 1
and
TX CODE 2
.
13. Press the [
DISP
] key or the
PTT
switch to save the
setting and return to normal operation.
14. Press the PTT switch to transmit a call to the specific
station.
• The reverse combination works as the same code, that is “05 47” is the same as “47 05”.
• If the same code is specified for all individuals, all the individuals can be called at the same
time.
• The default code is “05 47”.
• When receiving the codes, the sound of the tones may be heard intermittently.
Receiving “Pager Code” calls from a Remote Station (Standby Operation)
When the Pager function is activated, the audio of received calls with a corresponding
Pager Code is heard.
Furthermore, when the Bell function (see below) is activated, the bell rings when receiv-
ing calls from the other station.
Notification of a Call from a Remote Station by the Bell Function
The Bell may be set to sound an Alert when a call from another station containing a
cor-responding tone, DCS or pager code is received.
1. Press and hold the [
F(SETUP)
] key
[
SIGNALING
]
[
4 BELL RINGER
]
2. Rotate the
DIAL
knob to select the desired number of
times (1 - 8 times or continuous) the Bell rings.
1 time / 3 times / 5 times / 8 times / CONTINUOUS
If the setting is “CONTINUOUS”, the bell keeps
sounding until an operation is made.
1
2
3
4
AUTO DIALER
PAGER CODE >
PR FREQUENCY
BELL RINGER
OFF
SIGNALING
3. Press the [
DISP
] key or the
PTT
switch to save the setting and return to normal
operation, The “ ” icon appears on the display.