Yaesu FTM-200DR, Руководство по эксплуатации, Страница: 59 / 82

57
Band Scope
The Band Scope displays the current VFO frequency or Memory Chanel at the center of
of a Bar graph with the signal status of a number of frequencies or channels displayed to
the left and right at the bottom of the screen. The center frequency or memory channel
can be changed by turning the
DIAL
knob.
When there is a signal on the center channel, the bar graph display of other frequencies
is paused and you can hear the received audio. When there is no signal, the bar graph
display is automatically resumed.
1. Press the [
DISP ] key to display the band scope.
VFO mode:
The status (strengths) of the signals in the upper and
lower frequency channels (61CH or 31CH) centered on
the current receive frequency are displayed in the bar
graph.
The Band Scope frequency step is the same as the VFO
frequency step.
Memory mode:
• The status (strengths) of the signals in the upper and
lower memory channels (21CH or 11CH) centered on
the current memory channel are displayed in the graph.
• Memory channels that have not been registered are
not displayed.
• The bar graph for the central memory channel is
displayed in orange.
z
Change frequency or Memory Channels
Rotate the DIAL knob to change the receive frequency or
memory channel at the center of the band scope.
z
Exit the Band Scope
Press the [ DISP ] key.
Display example
VFO Mode (61CH)
Display example
MEMORY Mode (21CH)
z
Change the number of channels displayed
1. Press and hold the [
F menu
] key.
2. Rotate the DIAL knob to select [ SCOPE ], then press the DIAL knob.
3. Rotate the DIAL knob to select “ WIDE ” or “ NARROW ”.
The number of channels displayed in each mode is as follows:
WIDE NARROW
VFO mode
61 channels 31 channels
Memory mode 21 channels 11 channels
Factory default value: “WIDE”.
4. Press any key (except Power Switch) or PTT switch to conclude the the setting and
return to the original screen.