112
CW Narrow Filter XF-130CN
•
Be careful not to accidentally short-circuit the connection pins with a piece of metal.
•
A semiconductor may be damaged by static electricity, so do not handle it carelessly, touch it only when nec-
essary.
1. Turn OFF the FTDX10, and external DC power supply.
2. Referring to Figure 1, remove the 9 screws attaching the bottom case, then remove the bottom case.
3. Refer to Figure 2 for the mounting location for the XF-130CN.
4. Push the XF-130CN onto the pins corresponding to its assigned mounting location on the transceiver.
5.
Gently press the board down until it is firmly seated in its connectors.
Align the pin on the board with the hole of XF-130CN and insert it. Be careful when inserting the XF-
130CN as the number of pins is different (4 pins and 3 pins).
6. Replace the bottom case and its 9 screws.
XF-130CN
3-pin
4-pin
Figure 1
Figure 2
Carrying Handle MHG-1
•
Do not install the supplied MHG-1 Mounting Screws if you are not installing the MHG-1.
•
Do not use an improper screw for mounting the MHG-1! An improper screw may cause a “short circuit” to
the internal circuitry, causing serious damage.
Screw the Carrying Handle to the FTDX10 using the supplied screws.
Handle
Handle end Mounting Screw
Handle end
Mounting Screw
Содержание FTDX10
Страница 1: ...Operation Manual...