32
Functions to Use as Necessary
AF-DUAL Receive Function
The AF-DUAL Receive Function allows reception of a radio broadcast during standby
reception of A-band or B-band frequency (or frequency registered to a memory channel).
When standby reception is active, no audio is heard on the standby frequency, however
if a voice signal is detected, the reception of the broadcast radio will be paused, and the
receiver frequency will be heard.
Dual Receive is a similar function. When using the Dual Receive function, every time the
transceiver checks for a signal on the specified memory channel during radio reception,
the radio reception is interrupted (approximately every 5 seconds). When using the
AF-DUAL Receive Function, the radio reception is interrupted only when there is a calling
signal from another transceiver.
1. Set the A-band or B-band frequency for standby receive during broadcast radio
reception.
2. Press the [
F
MENU
] key
[
A.DUAL
].
•
If [
A.DUAL
] is not displayed, touch [
BACK ←
] to
display [
A.DUAL
] and then touch it.
• The AF-DUAL function is activated, and AF DUAL
“
” icon will be displayed.
• Pressing the [
BAND
] key each time switches
between the AM broadcast (middle wave band) and
FM broadcast.
3. Rotate the DIAL knob to tune to the frequency of the
broadcast station.
• The AF-DUAL receive function can also be used to monitor a radio frequency registered
to a memory channel or memory bank.
• Pressing [
MONI
] switch during radio reception, allows receiving the standby frequency.
• While listening to the radio using the AF-DUAL function, in standby receive mode, the
transceiver cannot simultaneously receive broadcasts on the AM frequency (middle wave
band) on either the A-band or B-band, and FM frequency.
z
Disable the AF DUAL function
1. Press the [
F
MENU
] key
[
A.DUAL
].
