46
y
4 APRS MODEM
APRS baud rate settings
Setting Item:
OFF / 1200bps / 9600bps
Default:
OFF
Explanation:
OFF:
Turn APRS function [OFF].
1200bps: Sets APRS baud rate to 1200bps.
9600bps: Sets APRS baud rate to 9600bps.
y
5 APRS MSG FLASH
Setting for strobe flash when there is an incoming message.
Setting Item:
MSG: OFF / 2 sec - 60 sec / CONTINUOUS / EVERY 2 s - 10 m
GRP: OFF / 2 sec - 60 sec / CONTINUOUS
BLN: OFF / 2 sec - 60 sec / CONTINUOUS
Default:
MSG: 4sec. / GRP: 4sec. / BLN: 4sec.
Explanation:
The strobe (white LED) flashes depending on settings in each of the following: [MSG]
when a message is received, [GRP] when a group message is received, [BLN] when a
bulletin message is received.
Strobe (white LED) flashes continuously when COUNTINUOUS is selected.
If the interval is set as Every 2 sec - Every 10 sec in “MSG”, the indicator will blink as
follows.:
Every 2 sec - Every 5 sec
1 flash for the set time interval
Every 6 sec - Every 9 sec
2 flashes for the set time interval
Every 10 sec - Every 50 sec
3 flashes for the set time interval
Every 1 min - Every 5 min
4 flashes for the set time interval
Every 6 min - Every 10 min
5 flashes for the set time interval
The strobe (white LED) will not flash if [OFF] is selected.
When Every 2 sec - Every 10 min is selected in “MSG”, and a GRP (Group) or BLN
(Bulletin) message is received while the light is blinking after receiving a message, the
light of the group or bulletin will blink for a while and then the message light will return to
blinking at the end of the reception.