9
Setting the DCS CODE
1. Touch [
F MW
]
[
SQTYP
]
.
If [
SQTYP
] is not displayed, touch [
FWD →
] to display [
SQTYP
] and then touch it.
2. Rotate the
DIAL
knob to select “DCS”.
3. Press the
PTT
switch to save the setting and return to normal operation.
4. Touch [
F MW
]
[
CODE
]
.
5. Rotate the
DIAL
knob to select the DCS code.
6. Press the [
BACK
] key to save the detected tone
frequency and return to normal operation.
2 DCS CODE
DCS : 023
•
The DCS code set by the above operation is the common setting for all transmissions with
a DCS Code (DCS, D CODE, T DCS, D TONE).
•
The default DCS code is “023”.
Searching for the DCS Code Used by the Other Station
Search for the DCS code used by the other station.
1. Touch [
F MW
]
[
SQTYP
]
.
If [
SQTYP
] is not displayed, touch [
FWD →
] to display [
SQTYP
] and then touch it.
2. Rotate the
DIAL
knob to select “DCS”.
3. Press the
PTT
switch to save the setting and return to normal operation.
4. Touch [
F MW
]
[
CODE
]
.
The DCS code setting screen is displayed.
5. Touch [
SEARCH
].
•
The transceiver starts to search for the DCS code.
•
When a corresponding DCS code is detected, a
beep sound is emitted. The detected DCS code
blinks. The searching stops for 5 seconds and the
audio is heard.
2 DCS CODE
DCS : 023
6. Touch [
STOP
] to stop searching.
7. Press the [
BACK
] key to save the detected DCS code and return to normal
operation.
To set the transceiver operation when scanning stops, press and hold the [
DISP
] key
[
SCAN
]
[
4 SCAN RESUME
]. This setting is common for all scan settings, the tone search
function and DCS search function.