Yaesu FT-70DR, Руководство по эксплуатации

Страница: 27 / 44

25 FT-70DR/FT-70DE Operating Manual
Registering to Memory Channels
1. Set the frequency and the communication mode
to be registered to a memory channel.
2. Press the [
V/M
] key.
“ ” blinks on the LCD.
3. Rotate the DIAL knob to select the desired
channel number.
The channel numbers that do not contain mem-
ory data will blink on the LCD.
4. Press the [ V/M
] key.
• If you attempt to register a frequency to a
memory channel that already contains fre-
quency data, “
M-WRT?
” will appear on the
LCD. Press the [ V/M
] key to overwrite the
memory channel.
• The memory tag input screen will be displayed on the LCD.
5. Input the memory tag.
• Use the numeric keys or the DIAL knob to in-
put the characters.
Memory Channel
Number
• Example : Rotating the DIAL knob to display the following characters.

A
-
Z

(symbol)

0
-
9

(symbol)

A
-
Z

• Example : Press the [ 2
] key repeatedly to toggle among the following available characters.
A → B → C → 2 → A ···
• Moving the cursor and deleting the input characters
[
BAND
] key
: Moves the cursor to the right
[
MODE
] key
: Moves the cursor to the left
[
GM
] key (press and hold) :
Erases all characters after the cursor
6. Press and hold the [ V/M
] key.
The beep sounds and the memory is saved.
Recalling a Memory Channel
1. Press the [ V/M
] key.
The memory channel most recently used appears on the LCD.
2. Rotate the
DIAL
knob to select the desired memory channel, or input the 3 digits of
the memory channel using the numeric keys to recall the memory channel directly.
3. Press the [ V/M
] key to exit the memory mode, and return to the normal operation.
z
The data registered to a memory channel can be transferred to the VFO operating band by
following the procedure below:
Press and hold the [ V/M
] key

Rotate the DIAL knob to select the channel

Press and hold
the [ GM
] key

“ V-WRT? ” appears

Press the [ GM
] key.
z
Pressing the [ F
] key and then rotating the
DIAL knob allows skipping memory channels quickly
in steps of 10 memory channels.
z
The transceiver may be placed into a Memory Channel Only mode, (which restricts the FT-70DR/DE
to operate only on the memory channels), by pressing the [ V/M
] key, while pressing the
Power
(
Lock
)
switch to turn the transceiver ON . To cancel the Memory Channel Only mode, turn the transceiver
OFF , then press the [ V/M
] key again, while pressing
Power
(
Lock
) switch to turn the transceiver
ON .