Yaesu FT-4VE, Руководство по эксплуатации

Страница: 19 / 40

17
Repeater Operation
Communicating Via the Repeater
The transceiver includes an ARS (Automatic Repeater Shift) function which
sets the repeater operation automatically when the receiver is tuned to the
repeater frequency.
1. Set the downlink (output) frequency from the re-
peater.
2. “ ” or “ ” lcons may automatically appear
above the frequency,
Repeater shift icon
● The reverse state
The “reverse” state temporarily reverses the transmit and receive frequen-
cies. This allows checking to find if direct communication with the other
station is possible.
1. Press the Function key, and then press the [ P2 ]
key.
The transmit and receive frequencies are tempo-
rarily reversed (“reverse” state).
In the “reverse” state, the “ ” or “ ” blinks on
the LCD.
2. Press the Function key to exit from the “reverse”
state.
Repeater shift
Reverse state (Blinking)
• The repeater settings may be changed from the Set Mode.
Set mode “ 30 RPT.FRQ ”: Allows changing the repeater shift offset ( 28).
Set mode “ 31 RPT.SFT ”: Allows setting the repeater shift direction ( 28).
Set mode “ 29 RPT.ARS ”: Allows setting the ARS function ( 28).
Tone Calling (1750 Hz)
If your transceiver is
FT-4VE
(European version), press and hold in the
MONI/
T-CALL
switch to generates the 1750 Hz burst tone to access the European
repeater.
The transmitter will automatically be activated, and the 1750 Hz audio tone
will be superimposed on the carrier. Once the repeater has been accessed,
release the
MONI/T-CALL
switch, and use the
PTT
switch to activate the
transmitter thereafter.
If needed, the
FT-4VR
(USA/Asian version), may be set to access repeaters
which require a 1750 Hz burst tone by setting the
MONI/T-CALL
switch to
serve as a “Tone Call” switch instead. To change the configuration of the
MONI/T-CALL switch, use Set Mode “ 19 M/T-CL ” ( 27 ).