Yaesu DR-2X, Руководство по эксплуатации, Страница: 37 / 52

DR-2X / DR-2XE Operating Manual 35
Setting the half deviation operation
1 Touch [ A SETUP
] or [
B SETUP
], and then touch [
F
].
2 Touch [ DEVIATION
] to display “NARROW”.
The setting will toggle between “NARROW” and “WIDE” each time
[
DEVIATION
] is touched.
NARROW : Reduces the analog FM/C4FM digital modulation to half.
WIDE : Uses the normal analog FM/C4FM digital modulation.
3 Touch [ BACK
] twice.
The setting is determined and the display will return to the operation
mode screen.
z
Factory default: WIDE
z
This setting item may be set on CH-A and CH-B individually.
Setting the tone signals for analog FM mode
Setting the tone frequency
1 Touch [ A SETUP
] or [
B SETUP
], then touch [
F
].
2 Touch [ SIGNALING
].
3 Touch [ ◄ ►
]
to select the “RX TONE FREQ” and the “TX TONE FREQ”.
4 Touch [ ▲
] or [
▼
].
The set value will change each time [ ▲
] or [
▼
] is touched.
5 Touch [ BACK
] 3 times.
The setting is determined and the display will return to the operation
mode screen.
z
Factory default: 100.0 Hz
z
Tone frequencies between 67.0 Hz and 254.1 Hz can be selected.
z
Both TX and RX can be set to different Tone frequency.
z
This item may be set separately on the CH-A and CH-B.
Setting the DCS code
1 Touch [ A SETUP
] or [
B SETUP
], then touch [
F
].
2 Touch [ SIGNALING
], then touch [
DCS CODE
].
3 Touch [ ◄ ►
]
to select the “RX DCS CODE” and the “TX DCS CODE”.
4 Touch [ ▲
] or [
▼
].
The set value will change each time [ ▲
] or [
▼
] is touched.
5 Touch [ BACK
] 3 times.
The setting is determined and the display will return to the operation
mode screen.
z
Factory default: 023
z
DCS codes between 023 and 754 can be selected.
z
Each TX and RX can be set to different code.
z
This setting item may be set on the CH-A and CH-B individually.
 8 4  
D G - I D
T - O F F
R - O FF
 8 4  
D G - I D
T - O F F
R - O FF
 8
4  
D G - I D
T - O F F
R - O FF